Bronco L6-300 4.9L VIN Y 1-bbl (1983)
FIGURE 8
Apply 3M Superduty Rubbing Compound (medium) to the panel and using a clean 2 + 2 pad on the wheel (as noted above) spread the compound evenly
and buff the surface until the condition is removed; or in the case of a sanded area, the sanding marks are gone and the luster
is restored to an acceptable level for polishing (Figure 7 and Figure 8). When buffing, keep the wheel flat to the surface using light to moderate pressure
and long even strokes. Periodically check the finish and add compound as required. When buffing is complete, polish the panel as described above.
Sanding
For removal of severe conditions such as heavy dirt particles, deep scratches and orange peel. This wet sanding procedure utilizes 3M Ultra Fine
Imperial Wetordry Color Sanding Paper to facilitate removal of surface damage. The Ultra Fine paper cuts quickly leaving a uniform finish that requires
a minimum of buffing to restore the luster.
FIGURE 9
1.
Soak the 3M Imperial Wetordry Paper and a 3M Imperial Wetordry Sponge Pad thoroughly in clean water and wrap the paper around the pad
as shown in Figure 9.
