Bronco L6-300 4.9L VIN Y 1-bbl (1983)
FIGURE 34
13.
If tailgate has heated glass option, disconnect two terminals (driver side) (Figure 34, View 6).
14.
Pull glass to full open position and support glass (Figure 34, View 5).
15.
Disconnect motor wiring harness.
16.
Remove power motor attaching screws (4).
17.
Reinstall new power motor.
18.
Install glass bracket "C" channels onto the regulator arm slide guides (Figure 34, View 7).
19.
Position tailgate glass over glass bracket "C" channel studs and install (4) screw and nut retainers (6-11 ft.lbs. torque) (Figure 34, View 7).
20.
Lower glass to connect heated glass wiring terminals.
21.
Close tailgate and cycle glass to assure smooth operation.
22.
Open tailgate and apply body color touch up paint to drilled hole surfaces.
23.
Install inside cover panel support (1 screw).
