Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Brake Pad: All Technical Service Bulletins
Brakes (Rear) - Accelerated Wear
Articles No. 84-16-28
BRAKE, REAR - ACCELERATED WEAR - VEHICLES WITH 11" DIAMETER REAR BRAKES
LIGHT TRUCKS 1975-84 E & F-100/150 & BRONCO
This article supersedes TSB article 83-25-18, dated December 13, 1983, to include all 1975-84 E & F-100/150 & Bronco vehicles that have 11"
diameter rear brakes.
Some E and F-100/150 and Bronco vehicles subjected to extreme duty cycles in urban delivery/service operations may experience accelerated rear brake
wear. A service kit(E0UZ-2C178-A) has been released for these vehicles and should be installed in its entirety if the vehicle exhibits any of the following
conditions:
^
Side to side imbalance in rear braking effectiveness.
^
Side to side imbalance in rear brake lining wear.
^
Excessive heat ("blued" shoes and/or drums).
The service kit consists of replacement front and rear brake linings, rear wheel cylinders and a proportioning valve. These parts must be installed per the
appropriate shop manual installation procedure.
NOTE:
If a misalignment between the drum braking surface and the shoe ledge guides of the brake backing plate is suspected, refer to TSB 82-24 for
the appropriate service procedures before installing the service kit (E0UZ-2C178-A).
PART NUMBER
PART NAME
CLASS
E0UZ-2C178-A
Brake Service Kit
C
Front/Rear Services
OTHER APPLICABLE ARTICLES: 82-24-17
ARTICLE SUPERSEDED: 83-25-18
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP2178A83
TIME:
2.3 Hrs. DLR. CODING: Basic Part No. 2200 Code: 30
