Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Brake Caliper: Service and Repair
Assembling Caliper
1.
Lubricate piston seal with clean brake fluid and position seal in groove in cylinder bore.
2.
Coat outside of piston and both beads of dust boot with clean brake fluid, then insert piston through dust boot until boot is around closed end of
piston.
3.
Hold piston and dust boot directly above caliper cylinder bore and use fingers to work bead of dust boot into groove near top of cylinder bore.
4.
One bead is seated in groove, press straight down on piston until piston bottoms in bore. Ensure piston is not cocked in bore.
