Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Figure 21 - TANK CLAMPED TO HEADER FOR CRIMPING - F SERIES AND BRONCO
Figure 22 - LOCKING TYPE PLIERS
6.
Clamp the tank in position on the header with two header clamps as shown (Figure 21). Tighten the header clamps to compress the O-ring gasket.
7.
If locking-type pliers are used to squeeze the header tabs against the tank, install a hex nut on the pliers adjusting screw.
8.
With the jaws of the locking-type pliers closed and locked, turn the adjusting screw to position the jaws against the shank of a 13/32 inch drill bit.
Then tighten the hex nut on the adjusting screw against the handle to lock the adjustment in place (Figure 22).