Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Figure 20 - RADIATOR DISASSEMBLED - F-150 THROUGH F-350 AND BRONCO
2.
Remove the retaining nuts and washers from the oil cooler inlet and outlet connections. Then, lift the oil cooler from the radiator outlet tank
(Figure 20).
3.
Remove the rubber gaskets from the oil cooler inlet and outlet connections if the oil cooler is to be reused.
Installation
1.
Install new rubber gaskets on the oil cooler inlet and outlet connections (Figure 20).
2.
Position the oil cooler to the radiator outlet tank and insert the inlet and outlet connections through the holes in the outlet tank.
3.
Install the flat washer and nut on each oil cooler connection to retain the oil cooler in the radiator outlet tank.
4.
Tighten the oil cooler retaining nuts to 12-15 Nm (9-11 ft.lbs.).
5.
Install the outlet tank on the radiator core header as outlined.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: "INFORMATION ONLY"
