Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Oil Pan: Service and Repair
Fig. 34 Oil pan rear seal installation
Fig. 41 Oil pan installation. 6-300 engine
6-300 EXC. ECONOLINE
1.
Drain cooling system and engine oil.
2.
Remove radiator.
3.
On 1981-87 F-100-250 California models, remove combination air bypass/air control valve from rear of engine.
4.
On all models, raise and support vehicle.
5.
Remove starter motor.
6.
Remove engine front support insulator-to-support bracket attaching nuts and washers.
7.
Raise front of engine using a suitable jack and wooden block. Position 1 inch wooden blocks between front support insulators and support
brackets, then lower engine to rest on blocks and remove jack.
8.
Remove oil pan and inlet tube attaching bolts.
9.
Remove inlet tube and screen from oil pump and lay in oil pan, then remove oil pan from vehicle.
10.
Reverse procedure to install, Figs. 40 and 41.
