Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Figure 12
5.
Using thread sealer or teflon tape on the threads of the PSI gauge, install gauge and tighten into new cover and air chamber, Figure
12.
After installation is made, this assembly should not be disassembled.
6.
Position small, plastic gasoline sample container and gas cup holder into gauge and vial cavity of die-cut, foam material for storage, Figure 12.
7.
Care should be taken when storing unit to prevent damage which could then cause bad readings when checking gasoline vapor pressure.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: "INFORMATION ONLY"
