ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

TFI Module/PIP Sensor - New Diagnostic Procedure|Page 164 > < TFI Module/PIP Sensor - New Diagnostic Procedure|Page 162
Page 11
background image

EQUIPMENT

Obtain the following test equipment or an equivalent:

^

Spark Tester, Special Service Tool D81P-6666-A. See note.

^

Volt/Ohm Meter Rotunda 014-00407.

^

12 Volt Test Light.

^

Small straight pin.

^

Remote Starter Switch.

^

TFI Ignition Tester, Rotunda 105-00003.

NOTES

^

A spark plug with a broken side electrode is not sufficient to check for spark and may lead to incorrect results.

^

When instructed to inspect a wiring harness, both a visual inspection and a continuity test should be performed.

^

When making measurements on a wiring harness or connector, it is good practice to wiggle the wires while measuring.

^

References to pin-in-line connector apply to shorting bar type connector used to set base timing.

^

This procedure is intended to identify faulty components or wiring while the fault is present. If the complaint is of an intermittent condition refer to
Intermittent Diagnosis.

Functional Schematic

TFI-IV

Closed Bowl

Distributor
The TFI-IV Closed Bowl Distributor system electrical schematic is shown below. For detailed information, refer to the vehicle wiring diagram.

Ignition Coil Secondary Voltage - Crank Mode

TFI Module/PIP Sensor - New Diagnostic Procedure|Page 164 > < TFI Module/PIP Sensor - New Diagnostic Procedure|Page 162