Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Diode Trio: Testing and Inspection
Fig. 9 Regulator plug. Jumper wire connection
Test Procedure
1.
Disconnect electric choke, if equipped.
2.
Disconnect voltage regulator wiring connector.
3.
Connect a jumper wire between the ``A'' and ``F'' terminals of the voltage regulator wiring connector, Fig. 9.
4.
Connect voltmeter to battery clamps. Then, start and idle engine.
5.
Observe and note voltmeter reading.
6.
Move the voltmeter positive lead to the alternator ``S'' terminal and note voltage reading.
Test Results
1.
If voltmeter reading is within {1/2} of battery voltage, the diodes are satisfactory.
2.
If voltmeter reading is approximately 1.5 volts, the alternator has a shorted negative diode or a grounded stator winding.
3.
If voltmeter reading is approximately 1.5 volts less than battery voltage, the alternator has a shorted positive diode.
4.
If voltage reading is approximately 1 to 1.5 volts less than {1/2} battery voltage, the alternator has an open positive diode.
5.
If voltage reading is 1 to 1.5 volts above {1/2} battery voltage, the alternator has an open negative diode.
6.
Reconnect electric choke into circuit after tests are completed, if equipped.
