Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Fig. 4 Installing Slipper Springs
Fig. 5 Installing Slippers
1.
Position rotor on rotor shaft splines with triangle detent on rotor counter bore facing upward.
2.
Install snap ring into groove on end of rotor shaft, Fig. 1.
3.
Position insert cam over rotor. Ensure recessed notch on insert cam is facing upward.
4.
With rotor extended upward approximately half out of cam, insert spring into rotor picket, Fig. 4.
5.
Use a slipper to compress spring, then install slipper with groove facing cam, Fig. 5.
6.
Perform steps 4 and 5 on slipper cavity beneath opposite inlet recess.
7.
While holding cam stationary, index rotor left or right one space and install another spring and slipper until all ten rotor cavities have been filled.
Ensure rotor springs and slippers remain in position while turning.
8.
Apply Loctite No. 242 or 271 adhesive or equivalent to outside diameter of seal and Lockquick NF or T primer or equivalent to seal bore in
housing. Install rotor shaft seal using tool No. T78P-3733-A3. Using a plastic mallet, drive seal into bore until properly seated.
9.
Position pump plate on flat surface with pulley side facing downward.
