Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Fig. 5 Installing driveshaft assembly
Fig. 6 Installing pump ring
Fig. 7 Installing rotor vanes
1.
Lubricate new O-ring seals with Vaseline and place in pump housing.
2.
If drive shaft oil seal was removed during disassembly, lubricate new seal with Vaseline. Then install seal in pump body front hub, using a suitable
seal driver.
3.
Position thrust plate and rotor on drive shaft. Then install rotor retaining ring in groove of drive shaft, Fig. 4.
