Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Band: Adjustments
C5 Transmission
Intermediate Band
Intermediate Band Adjustment
1. Clean all the dirt from the band adjusting screw area. Remove and discard the locknut
2. Install a new locknut on the adjustment screw.
3. Tighten the adjusting screw using Band Adjusting Ratchet T71 P-77370-H and Socket T71 P-77370-D or equivalent. Tool T71 P-77370-H or
equivalent, is a pre-set torque wrench which will click when the torque on the adjusting screw reaches 13.5 Nm (10 lb-ft).
4. Back off the adjusting screw exactly 4 1/4 turns.
5. Hold the adjusting screw from turning and tighten the locknut to 54 Nm (40 lb-ft).
Low/Reverse Band
Low Reverse Band Adjustment
1. Clean all the dirt from the band adjusting screw area. Remove and discard the locknut.
2. Install a new locknut on the adjusting screw.
3. Tighten the adjusting screw using Band Adjusting Ratchet T71 P-77370-H and Socket T71 P-77370-D or equivalent. Tool T71 P-77370-H or
equivalent, is a pre-set torque wrench which will click when the torque on the adjusting screw reaches 13.5 Nm (10 lb-ft).