Bronco L6-300 4.9L VIN Y 1-bbl (1983)
95-135 N.m (70-1OO ft-lbs).
5. Connect the shock absorber to the axle arm assembly. Install nut and tighten to 57-97 N.m (42-72 ft-lbs).
6. Connect the tie rod ball joint to the spindle. Install nut and tighten to 68-101 N.m (50-75 ft-lbs).
7. Lower the jacks from the axle arms.
8. Install the disc brake caliper as described in Section Disc Brakes Single Piston, Sliding Caliper. See: Brakes and Traction Control
9. Install the wheel and tire assembly. Install lug nuts and tighten to 115-155 N.m (85-115 ft-lbs).
10. Connect the front output shaft to the front axle yoke. Install U-bolts and tighten nuts to 11-20 N.m (8-15 ft-lbs).
11. Remove the jacks and lower the vehicle.
