Bronco L6-300 4.9L VIN Y 1-bbl (1983)
6.
Remove the lock ring seated in the groove of the wheel hub.
7.
Remove the body assembly from the hub. If the body is difficult to remove, install two capscrews and pull the body assembly out of the hub.
8.
Remove the outer locknut from the spindle with a Spanner Locknut Wrench, T83T-1197-B.
9.
Remove the lockwasher from the spindle.
10.
Remove the inner locknut from the spindle using a Spanner Locknut Wrench, T83T-1197-B.
11.
Remove the hub and rotor assembly and outer bearing from the spindle.
12.
Remove the nuts retaining the spindle to the knuckle. Lightly tap the spindle with a rawhide hammer to remove it from the knuckle, 13. Remove
the splash shield from the steering knuckle.
FIGURE 13
14.
Remove slip yoke boot clamps on the R.H. axle shaft assembly. Pull the axle shaft out of the steering knuckle. Refer to Figure 13.
FIGURE 14
