Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Figure 18 - "V" SEAL TO SLINGER INSTALLATION
Figure 19 - APPLY GREASE TO SEAL LIP
2.
Press a new slinger on the axle shaft with an appropriate piece of press stock. Refer to Figures 17, 18 and 19.
Figure 19 - APPLY GREASE TO SEAL LIP
3.
Install the rubber V-seal on the slinger and axle shaft. The lip of the seal should face towards the spindle. Refer to Figure 19.
