Bronco V8-351 5.8L VIN G 2-bbl (1982)
d.
Knock the sleeve out of the blind side with a 3/8" (9.525 mm) drift punch and hammer, Figure 4.
CAUTION:
REMOVAL OF THE FASTENER WITH A CUTTING TORCH IS NOT RECOMMENDED BECAUSE OF PROBABLE DAMAGE TO THE
FRAME STRUCTURE.
3.
Line ream the existing hole through the liner, frame flange and crossmember to 9/16" (14.228 mm), Figure 5.
4.
Install a 9/16" Grade 8 nut (34990-S4), bolt (58698-S2) and washer (44880-S2), with nut/washer on the bottom, Figure 6.
a.
Push the bolt into place using a brazing rod to hold the bolt.