Bronco II 4WD V6-171 2.8L (1985)
8.
Strip 3/8" (9.525 mm) of insulation from each end of the wires attached to the mounting flange.
a.
Slide a 1" (25.4 mm) piece of heat shrink tubing over each end of wire.
b.
Wrap and solder the wires to the ring terminals of the RFI noise filter (red wire to positive terminal, black wire to negative terminals).
c.
Push heat shrink tubing over soldered wire ends and shrink.
9.
Attach jumper wires to the RFI noise filter spade terminals.
NOTE:
BE SURE TO OBSERVE POLARITY MARKINGS.
10.
Attach the jumper wires to the electrical fuel pump terminals.
NOTE:
BE SURE TO OBSERVE POLARITY MARKINGS.
11.
Use tie straps to attach the RFI noise filter to the pick-up/return tubing of the pump/sender unit.
NOTE:
MAKE SURE WIRES ARE SECURELY ATTACHED.
12.
Reinstall the fuel pump/sender in the vehicle. Refer to the appropriate service manual for service details and required parts.
PART NUMBER
PART NAME
CLASS
E7PZ-9B357-A
Noise Filter Kit
C
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES:
87-20-13
WARRANTY STATUS: Eligible Under Basic Warranty Coverage
OPERATION DESCRIPTION
TIME
911705A
Aerostar, Ranger And
1.5 Hr.
Econoline With Mid-Ship
Fuel Tank.
911705B
F-Series With Mid-Ship Fuel
1.3 Hr.
Tank Or Ranger With Aft Of
Axle Fuel Tank.
911705C
Bronco II, F-Series And
1.6 Hr.
Bronco With Aft Of Axle
Fuel Tank.
911705D
Econoline With Aft Of Axle
1.2 Hr.
Fuel Tank.
911705E
Additional Time - F-Series
0.2 Hr.
Equipped With Spare Tire
Carrier.
911705F
All Cars
1.3 Hr.
DEALER CODING
BASIC PART NO.
CONDITION CODE
9H307
56
OASIS CODES:
205000, 207000, 404000, 702000
