| Removal and Installation NOTE:The yaw rate sensor and accelerometer cannot be separated. | | -
Remove the right-hand front seat.
For additional information, refer to: Front Seat (501-10 Seating, Removal and Installation).
| | | -
Remove the front scuff plate trim panel.
For additional information, refer to: Front Scuff Plate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
| | | -
Remove the B-pillar trim panel.
For additional information, refer to: B-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
| | | -
Locally detach the carpet from the floor panel and crossmember. | | | -
Disconnect the yaw rate sensor and accelerometer electrical connector and position it to one side. | 6. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Yaw rate sensor and accelerometer assembly bracket bolts 7. To install, reverse the removal procedure. Installation Details Item 2 : Yaw rate sensor and accelerometer assembly with bracket WARNING:Make sure the yaw rate sensor and accelerometer assembly is correctly positioned. Failure to follow this instruction may result in personal injury. |
