| Removal and Installation Removal | | -
Remove the driver air bag module.
For additional information, refer to: Driver Air Bag Module (501-20 Supplemental Restraint System, Removal and Installation).
| | | -
NOTE:Turn the steering wheel to access the steering column upper shroud retaining clips. Detach the steering column upper shroud from the steering column lower shroud (steering wheel shown removed for clarity). - Using a thin bladed screwdriver, release the retaining clips (one each side).
| | | -
NOTE:Make sure the road wheels are in the straight ahead position. Centralize the steering and lock it in position. | | | -
CAUTION:Make sure the clockspring rotor is not allowed to rotate. Secure in the central position with a piece of suitable tape. Secure the clockspring rotor to the clockspring outer. | | | -
Disconnect the steering wheel electrical connector (vehicles with speed control shown). | | | -
Remove the steering wheel retaining bolt. | | | -
CAUTION:Care must be taken not to damage the clockspring pins. Remove the steering wheel. - Feed the driver air bag wiring harness through the steering wheel.
| Installation | | -
NOTE:When the clockspring is centralized, part of the flat flexible cable will be visible and is U-shaped. Look for the U-shaped part of the flat flexible cable to confirm the clockspring is centralized. | | | -
To install, reverse the removal procedure. | | |
