Ford Workshop Service and Repair Manuals

Locking Tool, Flywheel

303-393 (21-168)

1. Remove the clutch disc and pressure plate.
   For additional information, refer to: Clutch Disc and Pressure Plate (308-01, Removal and Installation).
   

2. Using the special tool, lock the flywheel and remove the flywheel retaining bolts.
   • Discard the flywheel retaining bolts.

3. Remove the special tool.

4. Remove the crankshaft rear seal carrier.
   • Discard the crankshaft rear seal carrier.

1. Clean the crankshaft journal.

2. 

   NOTE:Install a new crankshaft rear seal carrier.
   

   NOTE:A new crankshaft rear seal carrier is supplied with an installation sleeve which must be removed following installation.
   

   NOTE:Do not lubricate the seal or the crankshaft journal.
   Install the crankshaft rear seal carrier.

3. 

   NOTE:Install new flywheel retaining bolts.
   Using the special tool, install the flywheel.
   • Tighten the bolts in the sequence shown in two stages.
   • Stage 1: 30 Nm.
   • Stage 2: 80 degrees.

4. Remove the special tool.

5. Install the clutch disc and pressure plate.
   For additional information, refer to: Clutch Disc and Pressure Plate (308-01A, Removal and Installation).