In-vehicle Repair Special Tool(s) | Universal Flange Holding Wrench 205-072 | | Gauge, Bolt Angle 303-174 | | Remover, Crankshaft Seal 303-293 | | Installer, Crankshaft Front Seal 303-684/1 | | -
Remove the timing belt. For additional information, refer to: Timing Belt. | 2. Remove the components in the order indicated in the following illustration(s) and table(s). 3. To install, reverse the removal procedure. Removal Details Item 1 : Camshaft pulley bolt | -
Using the special tool, remove the camshaft pulley bolt. | Item 3 : Camshaft seal | -
Using the special tool, remove the camshaft seal. | Installation Details Item 3 : Camshaft seal | -
NOTE:New camshaft seals are supplied with an alignment sleeve which will be pushed out during installation. Using the special tool, install the camshaft seal. - Remove and discard the alignment sleeve.
| Item 1 : Camshaft pulley bolt | -
Using the special tool, install the camshaft pulley bolt. - Tighten the camshaft pulley bolt in two stages.
| |