| Removal and Installation Special Tool(s) | | Remover/Installer, Coolant Hose Clamp 303-397 | | | -
Drain the cooling system.
For additional information, refer to: Cooling System Draining, Filling and Bleeding (303-03B Engine Cooling - 1.6L Duratec-16V Ti-VCT (Sigma), General Procedures).
| | | -
Remove the throttle body.
For additional information, refer to: Throttle Body (303-04B Fuel Charging and Controls - 1.6L Duratec-16V Ti-VCT (Sigma), Removal and Installation).
| 4. Remove the components in the order indicated in the following illustration(s) and table(s). 2 - Coolant shutoff valve electrical connector 4 - Coolant shutoff valve O-ring seal 5. To install, reverse the removal procedure. Removal Details Item 1 : Coolant shutoff valve to thermostat housing coolant hose | | -
Using the special tool, disconnect the coolant shutoff valve to thermostat housing coolant hose. | |
/Description and Operation/Diagnosis and Testing/General Procedures/Removal and Installation//img/E48619.jpg)
