Removal and Installation | -
Disconnect the battery ground cable. For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | | -
Raise and support the vehicle. For additional information, refer to: Lifting (100-02 Jacking and Lifting, Description and Operation). | | -
Remove the radiator splash shield. | 4. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Cooling fan motor electrical connector 3 - Radiator support bracket rear retaining bolts 5. To install, reverse the removal procedure. | -
Initialize the door window motors. For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures). | Removal Details Item 2 : Radiator support bracket front retaining bolts | -
Install temporary radiator support bracket front retaining bolts. - Remove the radiator support bracket front retaining bolts.
- Install 30mm M8 bolts leaving 15mm of thread exposed.
| Item 4 : Cooling fan motor and shroud top retaining clips | -
Release the cooling fan motor and shroud top retaining clip. | Item 5 : Cooling fan motor and shroud | -
Press in the cooling fan motor and shroud bottom retaining clips. Lift up the cooling fan shroud until clear of the retaining brackets. Remove the cooling fan motor and shroud. | Installation Details Item 2 : Radiator support bracket front retaining bolts | -
1. Install the radiator support bracket front retaining bolts. - Remove the temporary radiator support bracket 30mm M8 retaining bolts.
- Install the radiator support bracket front retaining bolts.
| |