Removal and Installation Special Tool(s) | Remover/Installer, Cooling Hose Clamp 303-397 (24-003) | | -
Drain the cooling system. For additional information, refer to: Cooling System Draining, Filling and Bleeding (303-03C Engine Cooling - 1.8L Duratec-HE (MI4)/2.0L Duratec-HE (MI4), General Procedures). | | -
Remove the engine upper cover. | | -
Remove the air cleaner outlet pipe. | 4. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Throttle body electrical connector 5. To install, reverse the removal procedure. | -
Initialize the door window motors. For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures). | | -
NOTE:Do not press the accelerator pedal during the initialization period as this will prevent the complete initialization of the throttle body. Turn the ignition key to position II and wait for one minute to initialize the throttle body. | | -
Turn the ignition key to the OFF position. | Removal Details Item 2 : Radiator to throttle body coolant hose | -
Using the special tool, disconnect the radiator to throttle body coolant hose from the throttle body. | Item 3 : Throttle body to exhaust gas recirculation (EGR) valve coolant hose | -
Using the special tool, remove throttle body to EGR valve coolant hose from the throttle body. | |