Removal and Installation | -
Disconnect the battery ground cable. For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | | -
Detach the brake fluid reservoir from the bulkhead extension panel. | | -
NOTE:Make sure that the windshield wiper motor is in the park position. Remove the windshield wiper arms. | | -
Remove the cowl panel. - Detach the cowl panel retaining clips.
- Detach the cowl panel from the windshield glass lower weatherstrip and remove the cowl panel.
| | -
Remove the bulkhead extension panel. | 7. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Fuel injector wiring harness trunking retaining bolts 2 - Fuel injector electrical connectors 3 - Fuel temperature sensor electrical connector 4 - Camshaft position (CMP) sensor electrical connector 8. To install, reverse the removal procedure. | -
Initialize the door window motors. For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures). | Removal Details Item 5 : EGR valve tube retaining clamp | -
Make a note of the position of the EGR valve tube retaining clamp before removal. | Installation Details Item 6 : EGR valve tube retaining bolts | -
Do not tighten the EGR valve tube retaining bolts at this stage. | Item 7 : EGR valve tube support bracket retaining bolt | -
Do not tighten the EGR valve tube support bracket retaining bolt at this stage. | Item 5 : EGR valve tube retaining clamp | -
Install a new EGR valve tube retaining clamp in the same position as when removed. | | -
Tighten the EGR valve tube retaining bolts. | | -
Tighten the EGR valve tube support bracket retaining bolt. | |