ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Halfshaft Seal RH > < Halfshaft Seal LH

C-MAX 2003.75 (06.2003-)

Automatic Transmission/Transaxle - Vehicles With: 4-Speed Automatic Transmission (4F27E) - Output Shaft Speed (OSS) Sensor C-MAX 2003.75 (06/2003-)
In-vehicle Repair

Materials
Name
Specification
Automatic transmission fluid
WSS-M2C202-B 
Thread sealer
SD-M4G9107-A 

Removal

  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.
  1. Place a drain pan beneath the output shaft speed (OSS) sensor.

  1. Remove the OSS sensor.
    • Disconnect the electrical connector.
    • Remove the bolt.
    • Inspect the OSS bore.

  1. Inspect the O-ring seal for nicks or cuts; install a new as necessary.

Installation
  1. NOTE:
    NOTE:Apply a light coat of petroleum jelly to the O-ring before installation.
    NOTE:
    NOTE:Apply thread sealer to the bolt.
    Install the OSS sensor.
    • Connect the electrical connector.
  1. Lower vehicle.

  1. Check the transmission fluid level, add automatic transmission fluid as necessary.
  1. Start the engine and move the transaxle range selector lever through all gear positions.

Halfshaft Seal RH > < Halfshaft Seal LH