Disassembly and Assembly of Subassemblies Special Tool(s) | Installer, Rear Wheel Hub Seal 205-075 (15-036) | | Installer, Differential Double Lip Seal 308-203 (16-066) | | Remover, Differential Bearing Cone 205-176 (15-074) | | Installer, Transmission Extension Housing Seal 307-028 (17-002) | | Remover, Drive Pinion Seal 205-078 (15-048) | | Adapter for 206-066 205-066-03 (15-033-3) | | Installer, Rear Wheel Hub Seal 205-075 (15-036) | Disassembly | -
Remove the halfshaft seals (left-hand side shown). | | -
Using the special tool, remove the differential bearing cups (left-hand side shown). | | -
Using the special tool, remove the final drive input gear bearing cup. | | -
Using the special tool, remove the transfer shaft gear bearing cups (left-hand side shown). | | -
NOTE:Note the location of the bleed hole in the funnel in relation to the bottom of the case. NOTE:Inspect the bleed hole for foreign material. Remove the funnel. | | -
Rotate the transaxle 180 degrees. | | -
Using the special tool, remove the final drive input gear bearing cup. | Assembly | -
NOTE:The converter housing side bearing cups for the transfer shaft bearing and differential case bearing will be installed during the assembly of the transaxle. Using the special tool, install the final drive input gear bearing cup. | | -
Rotate the transaxle 180 degrees. | | -
NOTE:Note the location of the bleed hole. NOTE:Inspect the bleed hole for foreign material. Install the funnel. | | -
Using the special tool, install the transfer shaft gear bearing cups (left-hand side shown). | | -
Using the special tool, install the final drive input gear bearing cup (left-hand side shown). | | -
Using the special tool, install the differential case bearing cups (left-hand side shown). | | -
Using the special tool, install the halfshaft seals (left-hand side shown). | |