NOTE:The following sequence must be carried out within 60 seconds of the fuel filler flap being closed.
NOTE:Make sure the vehicle is in netural.
Start the engine.
NOTE:Allow the engine to idle (min 20 seconds).
NOTE:After approximately 25 seconds the PCL lamp will illuminate to indicate the resetting has been achieved.
Allow the engine to idle.
NOTE:Check the PCL lamp for illumination. If the PCL lamp is illuminated continue with the procedure. If the PCL lamp is not illuminated repeat the procedure and test the system.
Turn the ignition switch to position 0.
Turn the ignition switch to position II.
NOTE:Check the PCL lamp for illumination. If the PCL lamp is not illuminated the fuel additive service reset procedure has been completed. If the PCL lamp is illuminated repeat the procedure and test the system.
Turn the ignition switch to position 0.