Contour L4-122 2.0L CNG DOHC VIN Z SFI (1996)
Fig. 2 Powertrain alignment gauge tool installation
5. Install powertrain alignment gauge T94P-600-AH, or equivalent, to transaxle bracket and front subframe.
6. Torque two vertical bolts, then through bolt to 20 ft lb.
7. Torque righthand front engine support insulator bolts to front subframe to 7 ft lb. Observe position of righthand front engine support insulator.
Insulator must be centered in transaxle bracket and in perfect front-to-rear alignment.
8. Torque righthand front engine support insulator through bolt to 75-102 ft lb.
9. Remove three gauge tool bolts and gauge tool.
10. Install lefthand front engine support insulator to front subframe with two bolts. Torque bolts to 7 ft lb. Observe position of lefthand front engine
support insulator to ensure perfect front-to-rear alignment. Torque lefthand front engine support insulator bolts to 30-40 ft lb.
11. Install lefthand front engine support insulator through bolt.
12. Lower vehicle, then connect battery ground cable.
