Contour L4-122 2.0L CNG DOHC VIN Z SFI (1996)
^
The NGS tester will display:
^
The NGS tester will display:
^
The NGS tester will display:
^
Once the calibration is complete turn the ignition key to Off position.
^
Remove the power cable from the cigar lighter.
^
Disconnect the N1-124 cable from the NGS tester and from the diagnostic plug J108.
^
Remove V1-255 program card from the NGS tester.
^
Install center console left side trim panel.
NOTE:
Make sure your SBTS machine is updated with the February 98 CD.
44.
Calibrate powertrain control module by refering to SBTS for PCM calibrating procedure. Select the correct calibration code from the table as
shown.