Contour L4-122 2.0L CNG DOHC VIN Z SFI (1996)
Seal Overlap Position
7. Install seven pump support seal rings on pump support assembly, noting position shown in the Seal Overlap Position image.
8. Install oil pump driveshaft, then rotate shaft using a torque wrench, noting the following:
a. Maximum torque is 2 in lbs.
b. If torque wrench reading exceeds specification, disassemble and inspect oil pump assembly for contamination or improper end clearance.
9. Remove torque wrench and oil pump driveshaft, then install pump support thrust bearing on support and pour suitable ATF on seal rings.
10. Install forward/coast/direct clutch cylinder and reverse clutch drum on pump support, then air check by applying 40 psi compressed air into oil
pump body passages.
11. As air is applied, listen for clutch pack application. If a hissing or squeal occurs, a damaged or torn seal is indicated. Locate and repair as required.
