Contour V6-153 2.5L DOHC (1996)
Traction Control Module: Service and Repair
1. Disconnect battery ground cable.
2. Disconnect traction assist control electrical connector.
3. Remove plastic cover from traction assist control.
Accelerator Cable Removal From Upper Pulley
4. Rotate traction assist control upper pulley and disconnect accelerator
cable from upper pulley.
Accelerator Cable Removal From Lower Pulley
5. Rotate traction assist control lower pulley and disconnect accelerator cable from lower pulley.
6. Slide accelerator cables out of traction assist control housing.
7. Remove two traction assist control retaining bolts and traction assist control from mounting bracket.
8. Reverse procedure to install.
