Contour V6-153 2.5L DOHC VIN L SFI (1997)
Fuel Return Line: Service and Repair
Removal and Installation
REMOVAL
1. Observe fuel pressure release and fuel draining procedures.
2. Drain fuel from tank.
3. Disconnect the spring lock couplings from the fuel tubes in fuel compartment.
4. Unsnap fuel tubes from plastic retainers in engine compartment.
5. Raise vehicle on hoist.
6. Remove fuel tank.
7. Disconnect fuel supply return and vapor tube push connect fitting from fuel pump module.
8. Remove three fuel tube organizers retained to underbody.
9. Remove fuel and vapor return tube from vehicle.
INSTALLATION
1. Feed the front of the fuel and vapor return tube assembly up between engine and dash panel.
2. Secure fuel and vapor return tube assembly to the underbody by installing three fuel tube organizers.
3. Connect fuel supply return and vapor tube push connect fitting to fuel pump module.
4. Install fuel tank.
5. Lower vehicle.
6. Snap in fuel tubes into plastic retainers in engine compartment.
7. Connect the spring lock couplings to the engine compartment tubes.
8. Fill fuel tank.
9. Start engine and check for leaks.