Contour V6-153 2.5L DOHC VIN L SFI (1997)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
NOTE: When battery voltage is removed from the Powertrain Control Module (PCM), all learned values will be cleared and reset to
predetermined values. When battery voltage is restored to the PCM, the vehicle may exhibit certain driveability concerns. It will be necessary to
drive the vehicle to allow the PCM to relearn values for optimum driveablilty and performance.
2. Raise vehicle on a hoist.
3. Remove splash shield from RH front fender apron.
4. Disconnect the fuel charging wiring or engine control sensor wiring from the Crankshaft Position (CKP) sensor.
5. Remove CKP sensor retaining bolt and remove CKP sensor.
INSTALLATION
1. Make sure CKP sensor mounting surface is clean. If equipped, make sure that the CKP sensor O-ring is in proper location on CKP sensor.
2. Position CKP sensor and install retaining bolt. Tighten retaining bolt to 8-12 Nm (71-106 lb-in).
CAUTION: Do not overtighten CKP sensor retaining bolt or damage to the CKP sensor may occur.
3. Properly route fuel charging wiring or engine control sensor wiring and connect electrical connector to CKP sensor.
4. Install splash shield. Tighten retaining screws securely.
5. Lower vehicle.
6. Connect battery ground cable.