Contour V6-153 2.5L DOHC VIN L SFI (1997)
10. Use a feeler gauge to measure the clearance between the reverse clutch pressure plate and the reverse clutch pressure plate retainer snap ring.
Make a second measurement on the opposite side. Average the two measurements to get the clearance.
11. The standard clearance is 0.33 to 0.89 mm (0.01 to 0.04 inch). If the clearance is not within the specification, select and install the proper
thickness snap ring to obtain the standard clearance.
Snap Ring Thickness mm (inch)
1.39-1.49 (0.055 to 0.059)
1.53-1.63 (0.060 to 0.064)
1.68-1.78 (0.066 to 0.070)