Crown Victoria V8-281 4.6L SFI (1998)
2. Remove brake tubes from primary and secondary outlet ports of brake master cylinder.
3. Disconnect the brake warning indicator switch connector.
4. Remove two nuts retaining brake master cylinder to power brake booster assembly.
5. Slide brake master cylinder forward and upward from vehicle.
INSTALLATION
1. Position brake master cylinder as an assembly on studs on booster assembly.
2. Install retaining nuts. Tighten retaining nuts to 21 - 29 Nm (16 - 21 ft. lbs.).
3. Install primary and secondary brake tubes to brake master cylinder outlet ports. Tighten to 14 - 20 Nm (10 - 14 ft. lbs.).
4. Connect brake warning indicator switch connector.
5. Fill brake master cylinder with specified brake fluid to between MAX line and 4.0 mm (0.16 inch) below MAX line of brake master cylinder
reservoir. Use High Performance DOT-3 Motor Vehicle Brake Fluid C6AZ-19542-AB or DOT-3 equivalent fluid meeting Ford specification
ESA-M6C25-A.
6. Bleed brake system.
7. Operate brakes several times, then check for external hydraulic leaks.
