Crown Victoria V8-281 4.6L SFI (1998)
2. Using a thin-blade cold chisel between rear brake anti-lock sensor indicator and axle shaft, strike chisel evenly around flange forcing rear brake
anti-lock sensor indicator off rear brake anti-lock sensor indicator journal. Discard rear brake anti-lock sensor indicator.
CAUTION: Use only a cold chisel, not a screwdriver. Extreme care should be taken not to scratch or nick rear wheel bearing and seal journal and
rear brake anti-lock sensor indicator journal.
NOTE: Prior to installation of new rear brake anti-lock sensor indicator, remove any burrs or nicks from journal.
INSTALLATION
1. Position Sensing Ring Replacer 206-057 (T94P-20202-A) on Axle Bearing / Seal Plate 205-090 (T75L-1165-B), placed on press bed as shown.
