Crown Victoria V8-281 4.6L SFI (1998)
REMOVAL
1. Remove the rear seat cushion.
2. Disconnect the rear anti-lock brake sensor electrical connector.
3. From below the vehicle, detach the three wire retaining clips from the vehicle.
4. Remove rear brake anti-lock sensor to rear wheel disc brake adapter retaining bolt and remove rear brake anti-lock sensor.
INSTALLATION
1. Insert rear brake anti-lock sensor into rear wheel disc brake adapter and install retaining bolt. Tighten to 5 - 6 Nm (45 - 53 inch lbs.).
2. Attach the wire retaining clips to the vehicle and position the electrical connector inside the vehicle through floor.
3. From inside the vehicle, connect the anti-lock brake sensor electrical connector.
4. Install the rear seat cushion.
