Crown Victoria V8-281 4.6L SFI (1998)
Vehicle Speed Sensor/Transducer - Cruise Control: Service and Repair
REMOVAL
1. Raise vehicle on a hoist.
2. Remove bolt retaining Vehicle Speed Sensor (VSS) mounting clip to transmission.
3. Remove VSS and driven gear from transmission.
4. Disconnect electrical connector from vehicle speed sensor.
5. Remove speedometer driven gear retainer. Remove driven gear from vehicle speed sensor.
INSTALLATION
1. Position driven gear to vehicle speed sensor. Install speedometer driven gear retainer.
2. Connect electrical connector.
3. Insert vehicle speed sensor into transmission housing. Install retaining bolt to VSS mounting clip. Tighten to 4-6 N.m (36-53 Lb-In).
4. Lower the vehicle.
