Crown Victoria V8-281 4.6L SFI (1998)
Suspension Control Module: Service and Repair
REMOVAL
WARNING: TURN AIR SUSPENSION SWITCH OFF TO PREVENT VEHICLE DAMAGE OR PERSONAL INJURY.
1. Remove glove compartment.
2. Remove control module from snap-in fingers on bracket behind glove compartment.
3. Pull control module out to gain access to control module connectors.
4. Disconnect each control module connector by pushing control module connector release button and pulling connectors from control module.
INSTALLATION
1. Connect control module electrical connectors to control module.
2. Install control module to bracket snap-in fingers behind glove compartment.
3. Install glove compartment.
4. Turn air suspension switch ON.
