Crown Victoria V8-281 4.6L SFI (1998)
5. Using C-Frame and Clamp Assembly 211-023 (T74P-3044-A1), press the wheel hub bolt from its seat and discard.
INSTALLATION
CAUTION: Never use air tools to install wheel hub bolts. The serrations can be stripped from the stud.
1. Insert a new wheel hub bolt in the hole in the axle flange, making sure serrations are aligned with those made by the original wheel hub bolt.
2. Place four flat washers over the outside end of the wheel hub bolt, and thread a standard lug nut with the flat side against the washers.
3. Tighten the lug nut until the wheel hub bolt head seats against the back side of the axle flange.
4. Remove the lug nut and washers.
5. Install the rear disc brake rotor, rear disc brake caliper support bracket and the rear disc brake caliper.
6. Install the wheel and tire assembly.
7. Lower the vehicle.
8. If equipped, turn the air suspension service switch, located in the luggage compartment, ON.
