Crown Victoria V8-281 4.6L SOHC (1992)
irritating to the skin.
^
Always wear gloves and safety glasses when handling a deployed air bag.
^
Wash your hands with mild soap and water afterwards.
General Instructions
^
Air bag modules with discolored or damaged cover deployment doors must be replaced, not repainted.
^
Because of the critical operating requirements of the system, do not attempt to service sensor clockspring, backup power supply or the
air bag module. Service is made by replacement only.
^
If ever a part is replaced and the new part did not correct the condition, reinstall the original part and perform the diagnostic
procedure again.
^
Never probe the connectors on the air bag. doing so may result in air bag deployment which could result in personal injury.
^
All component replacements and wiring service must be made with the positive battery cable disconnected for a minimum of one
minute before service or replacement is attempted.
^
The instruction "DISCONNECT" always refers to a connector. never detach a component from the vehicle when instructed to
"DISCONNECT".
^
Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag system is involved in a crash
where the fenders or grille area have been damaged, inspect the sensor mounting brackets for deformation. If damaged, the sensor
should be replaced whether or not the air bag is deployed. In addition, ensure that body structure in the area of sensor mounting is
restored to its original condition.
NOTE: After all service, verify the air bag indicator. This means turn the ignition switch to RUN and count the flashes only after the code (series of
flashes) has cycled twice. If the air bag indicator comes on continuously for 4 to 8 seconds and then goes out, the system is functioning properly and all
faults have been serviced.
