Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
For owner-paid repairs made before date of the Owner Letter (or after the date of the Owner Letter if an emergency repair was made away from the
servicing dealer), enter using DWE:
Attachment II - Labor and Parts Information
LABOR ALLOWANCES
PARTS REQUIREMENTS
Parts Ordering Information
No parts are required for this program.
CLAIMS PREPARATION
Enter using DWE.
Use code information shown below:
^
Program Code: 99B04
^
Labor Operation: B04B
See Sections 5 & 6 of the ACESII manual for detailed instructions.
Attachment III - Technical Information
AFFECTED VEHICLES:
CERTAIN 1999 MODEL YEAR CROWN VICTORIA POLICE INTERCEPTORS BUILT BEFORE NOVEMBER 20, 1998
SERVICE PROCEDURE
1.
Check the PCM calibration as follows:
^
Use the N.G.S., access PCM, pick "MODULE I.D." to determine necessary information.
^
Cross reference data to information below to determine the calibration level.
2.
If the calibration is not 9VNA-AAD, reflash Powertrain Control Module (PCM) to 9VNA-AAD (current R level) using one of the following two
(2) methods:
^
Service Bay Diagnostic System (SBDS).
