Crown Victoria V8-4.6L Flex Fuel (2008)
4. Remove the backrest trim panel.
1
Remove the 2 screws located at the bottom of the backrest trim panel.
2
Pull out at the bottom and slide the backrest trim panel up to disengage the 2 upper retaining hooks.
Non-Police vehicles
5. Release the backrest trim cover J-clips.
-
Release the lower J-clip first and then release the 2 side J-clips.
All vehicles
6. Remove the outboard hog rings that attach the foam pad to the seat backrest frame.
Vehicles with heated seats
7. Disconnect the backrest heated seat electrical connector.
Vehicles with power lumbar
8. Release the cushion trim cover rear J-clip.