Crown Victoria V8-4.6L Flex Fuel (2008)
9. Disconnect the LH rear parking brake conduit from the cable adjuster.
10. Disconnect the LH rear parking brake cable from the LH rear parking brake cable extension union and remove the LH rear parking brake cable
and conduit.
11. Press the retaining tabs and disconnect the RH rear parking brake cable and conduit from the frame bracket.
12. Remove the RH rear parking brake cable wire-form bracket bolts.
^
To install, tighten to 17 Nm (13 ft. lbs.)
13. Disconnect the RH rear parking brake cable and conduit from the axle housing clips.
14. Disconnect the RH rear parking brake cable from the RH rear parking brake cable extension union and remove the RH rear parking brake cable
and conduit.
15. To install, reverse the removal procedure.
^
Adjust the cable tension.
16. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.
17. If equipped, turn the air suspension service switch to the ON position.