Crown Victoria V8-4.6L Flex Fuel (2008)
1. NOTE: Align the gasket locator tabs with the slots in the cylinder head.
Install new intake manifold gaskets.
2. Install the intake manifold and hand-tighten the 8 bolts.
3. Install the 8 ignition coil-on-plugs.
4. Position the intake manifold crash bracket and loosely install the bolt and stud bolt.
5. Tighten the bolts in the sequence shown.
^
Tighten to 25 Nm (18 ft. lbs.).
6. Tighten the intake manifold crash bracket bolt.
^
Tighten to 25 Nm (18 ft. lbs.).
7. Install the EGR system module tube.
8. Install the intake manifold shield and the 2 bolts.
^
Tighten to 10 Nm (89 inch lbs.).
9. Connect the throttle control and the TP sensor electrical connectors.
10. Install the coolant thermostat.
11. Install the generator bracket and the 4 bracket bolts.
^
Tighten to 10 Nm (89 inch lbs.).
12. Connect the generator electrical connector.
13. Connect the EVAP canister purge valve hoses to the TB and the EVAP canister purge valve.
14. Connect the intake manifold vacuum hose to the TB spacer.
