Crown Victoria V8-4.6L Flex Fuel (2008)
Removal
1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire
Suppression System. Failure to follow the instructions may result in serious personal injury.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove both valve covers.
3. Remove the coolant pump. For additional information, refer to Cooling System.
4. Remove the crankshaft front seal.
5. Remove the 3 bolts and position the power steering pump aside.
6. Drain the engine oil.
^
Install the drain plug when finished.
^
Tighten to 23 Nm (17 ft. lbs.).
7. Remove the 4 front oil pan-to-engine front cover bolts.
8. Remove the bolt and the shield.
9. Remove the bolt and the accessory drive idler pulley.
10. Remove the bolts and the stud bolts in the sequence shown.
