Crown Victoria V8-4.6L Flex Fuel (2008)
4. Remove the 4 lower side air deflector pin-type retainers.
5. Remove the bottom cooling module air deflector.
6. Disconnect the 2 transmission cooler line fittings at the condenser.
7. Remove the 2 condenser fitting nuts and disconnect the fittings.
-
Discard the O-ring seals and gasket seals.
-
To install, tighten to 15 Nm (11 lb-ft).
8. Remove the 4 upper side air deflector pin-type retainers.
9. Remove the 2 cooling module bracket bolts.
-
To install, tighten to 10 Nm (89 lb-in).
10. Remove the 2 cooling module brackets.
11. Remove the condenser bolt.
12. Detach the power steering cooler from the cooling module clips.
13. Tilt the cooling module back and remove the condenser core.
14. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
To install, reverse the removal procedure.
-
Install new O-ring seals and gasket seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
15. Evacuate, leak test and charge the refrigerant system.
16. Fill the transmission fluid to the correct level.