Crown Victoria V8-4.6L Flex Fuel (2008)
Lamp Control Module: Service and Repair
LIGHTING CONTROL MODULE (LCM)
Removal and Installation
NOTE: Prior to removal of the module, it is necessary to upload module configuration information to a scan tool. This information needs to be
downloaded into the new module once installed.
1. NOTE: This step is necessary only if the lighting control module (LCM) is being replaced.
Upload the module configuration information from the LCM into the scan tool.
2. NOTE: A new LCM is delivered in a manufacturing mode with a pre-set DTC of B2477. This DTC will clear when the module has been
successfully configured (or programmable module installation [PMI]). DTC B2477 may need to be cleared after a successful configuration (or
PMI).